HS150HH Heidra Pump
The Godwin HS150HH hydraulic submersible pump is a compact self-contained pumping unit featuring a 6" (150 mm) submersible hydraulic side discharging pump and a diesel driven power pack. The HS150HH offers improved performance and operating efficiencies that cannot be matched by standard electric submersible models. With variable speed diesel engine power, the Heidra HS150HH can meet a variety of flow and head requirements up to 1,450 GPM (329 m3/h) and 280′ (85 m) of total dynamic head with a simple throttle adjustment. Add the ability to pass solids to 13⁄8" (35 mm) in diameter, dry-running capabilities and a cast chromium steel impeller, and you have a rugged dewatering/solids- handling, self-contained hydraulic submersible pump ready to go anywhere.
- Double mechanical seal in its own clean oil bath allows for indefinite dry-running. Inboard seal face is solid silicone carbide. The outboard seal is carbon or ceramic.
- The pump has independent bearings from the hydraulic gear motor, so pump loads do not affect gear motor performance.
- Open, solids-handling impellers with replaceable wearplates. Standard impeller is designed for general pumping, slurries and sludges.
- Piston motor connections are standard four-bolt SAE flange and shaft. This allows the bearing bracket to plug directly together.
- For ease of maintenance, the piston motor has a “plug-in” connection to allow for quick changeover when required.
Performance Table
Diesel Set — JD6068H
Power Output — 275 HP (205 kW) @ 2000 RPM
| GPM | 1400 | 1200 | 1000 | 800 | 600 |
| Feet | 210 | 300 | 350 | 380 | 400 |
| PSI | 91 | 130 | 152 | 165 | 173 |
Performance data listed in table and curves based on water tests at sea level and 68°F (20°C). Maximum flows may require larger diameter pipes.
Specifications
Pipe Connections
6′′ (150 mm) 150# Flange Discharge
Max. Flow
1,450 GPM (329 m3/h)
Max. Head
280′ (85 m)
Solids Handling
Up to 1-3/8′′ (35 mm)
Impeller Diameter
15-1/8′′ (385 mm)
Max. Working Pressure
4,000 PSI (276 BAR)
Max. Op. Speed
1,800 RPM (Engine) 2,400 RPM (Pump)
Max. Op. Temp.
+180°F (82°C)
Hydraulic Output
85 GPM (19.3 m3/h)
Hydraulic Resevoir
80 GAL (303 l)
Fuel Tank Capacity
175 GAL* (662.4 l)
Fuel Consumption @ 1,800 RPM (Full Load)
13.5 GPH (51 l/h)
*175 gal. (662.4 l) skid mount standard equipment
Parts & Material Type
Pump Casing and Suction Cover
Cast iron
Front and Rear Wearplates
Cast iron
Pump Shaft
1-1/2% Ni/CR steel
Impeller
Cast CR steel, 341 BN hardness
Mechanical Seal
Double seal in oil bath with solid silicone carbide faces
(HS200HH hydraulic pump end and skid mount shown below)
Skid Mount Dry Weight: 5,200 lbs. (2358.68 kg)
Pumpend Dry Weight: 784 lbs. (355.61 kg)
Product Datasheets
