HS80HH Heidra Pump
The Godwin HS80HH hydraulic submersible pump is a compact self- contained pumping unit featuring a diesel-driven power pack and 3" (75 mm) submersible hydraulic top-discharging pump. The HS80HH offers improved performance and operating efficiencies that cannot be matched by standard electrical submersible models. With variable speed diesel engine power, the Heidra HS80HH can meet a variety of flow and head requirements up to 450 GPM (28.4 l/s) and 325' (99 m) of total dynamic head with a simple throttle adjustment. Add the ability to pass solids to 1" (25 mm) in diameter, dry running capabilities, a cast chromium steel impeller, and you have a rugged dewatering/solids- handling, self-contained hydraulic submersible pump ready to go anywhere.
- Rugged construction featuring cast iron pumping chamber and cast chromium steel impeller.
- The pump has independent bearings from the hydraulic gear motor, so pump loads do not affect gear motor performance.
- Mechanical seal in its own clean oil bath allows for indefinite dry-running Seal faces are solid silicone carbide.
- Standard impeller is designed for general pumping, slurries and sludges.
- Gear motor connections are standard two-bolt SAE flange.
- For ease-of-maintenance, the gear motor has a “plug-in” connection to allow for quick changeover when required.
Performance Table
Diesel Set — JD 4045T280
Max Power Output — 71 HP (53 kw) @ 2400 RPM
Impeller Diameter — 12.8′′ (325 mm)
| GPM | 400 | 300 | 200 | 100 |
| Feet | 200 | 250 | 270 | 278 |
| PSI | 86.5 | 108 | 116.9 | 120.3 |
Performance data listed in table and curves based on water tests at sea level and 68°F (20°C). Maximum flows may require larger diameter pipes.
Specifications
Pipe Connections
3" (75 mm) 125#
Flange Discharge
Max. Flow
450 GPM (28.4 l/sec.)
Max. Head
325' (99 m)
Solids Handling
1" (25 mm)
Impeller Diameter
12.8" (325 mm)
Max. Working Press.
155 PSI (10.7 BAR)
Max. Casing Press.
232 PSI (16.0 BAR)
Max. Op. Speed
2,400 RPM
Max. Op. Temp.
+230°F (110°C)
Hydraulic Output
32 GAL (121 l)
Hydraulic Capacity
40 GAL (151 l)
Fuel Tank Capacity
60 GAL* (227 l)
Fuel Consumption
@ 2200 RPM (Full Load)
3.8 GPH (14.5 l/h)
*GP60 Trailer standard equipment
Parts & Material Type
Casing
Cast iron
Front and Rear Wearplates
Cast iron
Shaft
1-1/2% Ni/CR steel
Impeller
Cast CR Steel, 341 BN hardness
Bearing and Seal Housing
Cast iron
Mechanical Seal
Double mechanical seal in oil bath with solid silicone carbide faces
Lifting Bracket
Fabricated mild steel tube and plate
HS150MR hydraulic powerpack and HS80HH pumpend.
Product Datasheets
